Melbourne/Transformation Protocol

From 2007.igem.org

(Difference between revisions)
(Method including controls)
(Equipement Required)
Line 30: Line 30:
=====Equipement Required=====
=====Equipement Required=====
-
*1.5mL Microfuge tubes
+
*[[Melbourne/1.7ml microcentrifuge|microcentrifuge: 1.7ml]]
*Ice box
*Ice box
*Pipettes
*Pipettes
Line 37: Line 37:
*Bunsen burner
*Bunsen burner
*Spreader
*Spreader
 +
=====References=====
=====References=====
*
*

Revision as of 11:38, 28 September 2007

<Return to list of protocols> <Team home page>

  • Applications:
    1. Amplification of Biobrick DNA for storage and use.
    2. Selection and amplification of ligated constructs.
  • Time to complete protocol:
    • Lab time: 10min, 10min, 10min, 15min.
    • Waiting time: 45min, 15min, 1hour, overnight.
  • Approximate cost of materials: $

Method from primary and secondary reagents

Primary & secondary Reagents Required including controls
  • Competent cells (from -70degree freezer)
  • DNA for transformation
  • LB (cupboard)
  • LB-agar plates with selective antibiotic (cool room)
Method including controls
  1. Add 1uL resuspended plasmid DNA to 50uL competent cells.
  2. Incubate on ice for 45min.
  3. Heat shock in water bath at 42 degrees for 1min.
  4. Incubate on ice for 15min.
  5. Add 1mL LB (flame tip before use).
  6. Incubate at 37 degrees for 1 hour.
  7. Spin down cells and remove majority of LB.
  8. Resuspend cells in remaining LB.
  9. Under a bunsen spread resuspended bacteria on agar plate on selective antibiotic.
  10. Incubate plate overnight at 37 degrees.
  11. Place in cold room until needed.
Equipement Required
  • microcentrifuge: 1.7ml
  • Ice box
  • Pipettes
  • 42 degree water bath (balance room)
  • 37 degree incubator
  • Bunsen burner
  • Spreader
References


<Back to Protocols page>