ETHZ/Biology

From 2007.igem.org

< ETHZ
Revision as of 19:13, 22 October 2007 by Cbergeles (Talk | contribs)
Eth zh logo 4.png
Main Page      System Modeling      Simulations      System Implementation      Lab Notes      Meet the Team      Team Notes      Pictures!

.:: educatETH E.coli - Biology Perspective ::.

On this page, you can find an analysis of the function of our system, its biological design, and a list of the parts that make up the system. Are you interested in constructing educatETH E.coli in your lab? Then under Lab Notes, you can find the ingredients and equipment we used, the electronic version of our lab notebook and a presentation of all the difficulties that we encountered. If you are also interested in how educatETH E.coli was modeled and simulated outside the lab, please visit the modeling and simulations web pages.


Introduction

educatETH E.coli is a system which can distinguish between [http://openwetware.org/wiki/ATc anhydrotetracycline (aTc)] and [http://openwetware.org/wiki/IPTG Isopropyl-beta-D-thiogalactopyranoside (IPTG)] based on a previous training phase conducted with the same chemicals and the help of [http://partsregistry.org/Acyl-HSLs AHL]. It is composed of three subsystems: the subsystem of constitutively produced proteins, the learning subsystem and the reporting subsystem. The constitutively produced proteins (LacI, TetR and LuxR) control the learning subsystem. At the core of the latter there exists a modified and extended version of the Elowitz toggle switch found in [1]. The main difference is reflected in the use of double promoters, so that the toggle switch only changes its state when both, one of the two chemicals (aTc/IPTG), and AHL are present. As AHL is only present during the training phase, the toggle maintains its state during testing, and thus can “memorize”. AHL can therefore be seen as a training- or learning substance. In the reporting subsystem, four reporters ([http://partsregistry.org/Featured_Parts:Fluorescent_proteins fluorescent proteins]) allow supervision of both the chemical the system was trained with and if the system recognizes the chemical it is being exposed to in the testing phase as one it has been previously trained with or not.


The Complete System

The biological design of educatETH E.coli is presented in Fig. 1

Fig. 1: Gene interaction network of educatETH E.coli
and below, we clarify the function of all depicted components. (Are you interested in how the complex system of Fig. 1 was modeled? Then visit the System Modeling!)


Constitutive Subsystem

The constitutively produced proteins of the system are LacI, TetR and LuxR. The LuxR part has a special function: when AHL is present, it forms a LuxR-AHL complex which acts on the learning subsystem (more on this later). For now, we will consider that AHL is absent and therefore LuxR cannot act on any subsystems. The TetR and LacI parts behave similarly: more specifically, the TetR protein in the absence of aTc inhibits the production of P22 cII and LacI in the absence of IPTG inhibits the production of cI. When aTc is present, however, the P22 cII production is no longer inhibited (and thus p22 cII is produced). Correspondingly, cI is produced when IPTG is present.

Learning Subsystem

The learning subsystem is a toggle switch with two operator sites. The upper part of the toggle (cI production) has operator sites for the LuxR-AHL complex and P22 cII (which has in turn been induced by aTc). The LuxR-AHL complex induces the cI production, whereas P22 cII inhibits it. The lower part of the toggle (P22 cII production) has operator sites for the LuxR-AHL complex and cI (which has been induced by IPTG). Similarly with the upper part, the LuxR-AHL complex induces the P22 cII production and cI inhibits it. Therefore, the switch always requires the presence of the LuxR-AHL complex in order for it to operate. Its state depends on the presence of P22 cII and cI into the system, which in return was caused through the exposure of the system to aTc and IPTG.

Reporting Subsystem

There are four reporters in the system. CFP (more precisely: enhanced CFP, that is eCFP) and YFP (more precisely: enhanced YFP, that is eYFP) are active during the training phase of the system and show which chemical the system is exposed to during training, whereas all four reporters (the latter and GFP and RFP) are active during the testing phase and show if the system is exposed to the same chemical as in training or not. More specifically, the YFP protein production is regulated with help of two operator sites controlled by cI and aTc. cI inhibits YFP production and aTc induces it. Therefore, YFP is produced when the system is exposed to aTc. In a similar manner, the CFP production is produced when the system is exposed to IPTG. The GFP production is regulated with help of two operator sites controlled by lacI and .


System phases

The system operation is divided into two main phases: the training phase and the testing phase. The training phase itself is also subdivided into two phases: seeing and memorizing. During seeing, the system is first exposed to one of the two chemicals it is designed to recognize (aTc and IPTG). AHL is then added and the system’s internal toggle switch reaches a steady state. During memorizing, the chemical used during seeing is removed and only AHL is retained. This maintains the toggle switch to its acquired steady state, which is reported with YFP (if aTc was seen) or CFP (if IPTG was seen). During the testing phase, the system is exposed to any of the two chemicals (aTc or IPTG), with AHL present. By comparing its toggle switch state with the effect of the newly introduced chemical, the system shows a different response if it has previously been exposed to this chemical and reports with the same XFP as in the training phase (YFP for aTc, CFP for IPTG) or if it recognizes a different chemical and reports with a different XFP (GFP for trained with aTc and recognizing IPTG, RFP for trained with IPTG and recognizing aTc).The following table presents all possible paths that may be taken by the system during all phases of operation according to the external stimuli.

System phases
aTc IPTG AHL p22cII cI Reporting
Start
no input no no no no no no
Learning
Trained with aTc yes no no yes no YFP
Trained with IPTG no yes no no yes CFP
Memorizing
Trained with aTc yes no yes yes no YFP
Trained with IPTG no yes yes no yes CFP
Recognition
Trained with aTc
Tested with aTc
yes no yes yes no YFP
Trained with aTc
Tested with IPTG
no yes yes yes no GFP
Trained with IPTG
Tested with IPTG
no yes yes no yes CFP
Trained with IPTG
Tested with aTc
yes no yes no yes RFP


System parts

educatETH E.coli consists of 11 parts that can be synthesized independently (want to know how this is done in the lab? Then visit our In the Lab page!) Please note that four of them (4,5 and 8,9) form together two functional system units. They have been separated to ensure comparable part lengths and thus enable easier introduction into plasmids. A detailed list of the used parts can be found here (due to many pictures, it takes some time to load).


Applications

Besides being a nice model for describing learning behavior or epigenetics, our system-structure can also be used for potential real world applications:

Multipurpose Cell Lines

Our system can be trained to behave in a specific way by setting its inducible toggle switch to one of its two states. Let’s say this specific state triggers specific and different events such as enzyme synthesis, transcriptional regulation, virion production or cell death. In this case one can view the bacterial cell line containing this system as a multipurpose cell line. Put another way: One has a cell line and adds a certain chemical to train it to the desired behavior instead of constructing two independent cell lines. This means, one applies an “input engineering” instead of a “DNA engineering” approach. If one extends this idea to several inducible toggle switches being harbored in the same cell line, the number of possible phenotypes increases to 2n, whereas n equals the number of toggle switches. For example, if one would have 5 toggle switches inside a cell line, 32 different behavior patterns would be possible.

Intelligent Biosensors and Self-Adaptation

As a direct application of the multipurpose cell lines mentioned above, we constructed a system capable of sensing different chemicals and producing different fluorescent proteins. Since the cells can be trained to produce one of several specific fluorescent protein types when a certain chemical is present, one can also view those cells as intelligent biosensors, able to change their properties in a training phase.
It can also be possible that the environment (and its chemicals) itself is the training phase and hence that the biosensors are adapting themselves to this environment and hence the desired state.
Additionally, the intelligent biosensors are not limited to detect chemicals. Also temperature, pH or light etc. could be detected with an appropriate system.


References

[http://www.nature.com/nature/journal/v403/n6767/abs/403335a0.html [1] Elowitz MB and Leibler S] "A synthetic oscillatory network of transcriptional regulators", Nature 403:335-338, 2000

To Do

New

<p>
  • Update and correct parts in parts list. Write better in a table
  • Update and correct full system scheme
  • What is the proof of concept mentioned?
  • Are you sure about the reporters? This is not what I understood. I though YFP and CFP were also during testing. Yes! I'm still updating the text :-)
  • I don't think it is wise to make p22cII in P22 cII, since we have in the first way all over the place. Stefan: The problem is that the correct notation is P22 cII and I already used it in all the part describtions. But I could also change it back, no worries!
  • Try to improve table with system phases. It doesn't look so nice...
  • In the memorizing phase, is there color or not? - Nope, there is no color - There are colors, however they will disappear within 2-3 hours.
  • We need to put the complete spaghetti system as well.
  • Check my terminology (operator sites etc)
  • Put Stefan's updated part on epigenetics
  • Fill in table completely, make it more reading-friendly