Tokyo/Works/Assay2

From 2007.igem.org

(Difference between revisions)
(Objective)
Line 6: Line 6:
<!--<br>Fomulationで建てた式に必要なパラメータをAssay1により実験的に求めた。それを導入した結果を解析したところ、以下の実験の必要性が浮かび上がった。-->
<!--<br>Fomulationで建てた式に必要なパラメータをAssay1により実験的に求めた。それを導入した結果を解析したところ、以下の実験の必要性が浮かび上がった。-->
-
Parameters for the equations in [[Tokyo/Works/Formulation |Formulation]] have been experimentally determined in [[Tokyo/Works/Assay |Assay1]]. Analysing the result of [[Tokyo/Works/Simulation |the simulations]], the following experiments were turned out to be necessary.
+
Parameters for the equations in [[Tokyo/Works/Formulation |Formulation]] have been experimentally determined in [[Tokyo/Works/Assay |Assay1]]. Analyzing the result of [[Tokyo/Works/Simulation |the simulations]], the following experiments were turned out to be necessary.
== [[Tokyo/Activation check by cell-produced AHL |Activation check by cell-produced AHL ]] ==
== [[Tokyo/Activation check by cell-produced AHL |Activation check by cell-produced AHL ]] ==

Revision as of 03:35, 27 October 2007


Works top   0.Hybrid promoter   1.Formulation   2.Assay1   3.Simulation   4.Assay2   5.Future works

Activation check by cell-produced AHL    Expression level check on promoters + plasmid sets of A and B sides

Objective

Parameters for the equations in Formulation have been experimentally determined in Assay1. Analyzing the result of the simulations, the following experiments were turned out to be necessary.

Activation check by cell-produced AHL

Fig.1 By culturing with AHL producing cells, whether the lux lac hybrid promoter was activated without externally adding AHL. Regardless of the copy numbers of the luxI encoding plasmids, the hybrid promoter was activated.

Objective

To check whether worker E. coli (Sender) can produce enough amount of AHL for our model to work by using different copy numbers of plasmids


Result & Conclusion

Not only high copy number plasmid pSB1, but also low copy number plasmid pSB4 and pBR produced enough AHL to activate the LacI hybrid promoter in other cells. Especially, pBR remarkably produced AHL in the present experiment.


==> see more details






Expression level check on promoters + plasmid sets of A and B sides

Objective

Fig.2 Expression levels of the both sides were compared. As to the A side, RFP was substituted with GFP.


To test and compare the gene expression level of each side, A and B. Since the cell type - A or B - is detected based on the fluorescence, its activity should be measured and standardized beforehand. Here we used the same fluorescent protein GFP on the both promoter + plasmid sets actually used in our model, where A side consists of Lambda cI-regulated promoter, and B side the lux lac hybrid promoter.

Result & Conclusion


Two plasmid sets, A4 ΔP/pc1-GFP(upper side of Fig.2, off/on respectively) and A4 hybrid-promoter(+AHL to activate)/pBR322tetR (lower side of Fig.2, on/off respectively), showed almost the same fluorescence of GFP. This result indicates that expression levels of both sets were almost the same, though the latter was a bit smaller.
Fig.3 Genes downstream of the promoters on the both sides were expressed to almost the same degrees in terms of GFP fluorescence.




==> see more details