Calgary/protocols

From 2007.igem.org

(Difference between revisions)
Line 59: Line 59:
<hr />
<hr />
-
<p style="font-size:14px; font-weight:bold"><a name="transformation"> Bacterial Transformation</a> </p>
+
<p style="font-size:14px; font-weight:bold"><a style="text-decoration:none" name="transformation"> Bacterial Transformation</a> </p>
<ul>
<ul>
<li> Thaw 100 ul of competen cells (per transformation) on ice just before they are needed</li>
<li> Thaw 100 ul of competen cells (per transformation) on ice just before they are needed</li>
Line 79: Line 79:
</p>
</p>
-
<p style="font-size:14px; font-weight:bold"><a name="rehydration"> Rehydration </a> </p>
+
<p style="font-size:14px; font-weight:bold"><a style="text-decoration:none" name="rehydration"> Rehydration </a> </p>
<p> Biobrick parts are shipped from the registry in a dehydrated from. As such they must be rehydrated before they can be used. </p>
<p> Biobrick parts are shipped from the registry in a dehydrated from. As such they must be rehydrated before they can be used. </p>
<ul>
<ul>

Revision as of 18:23, 12 October 2007

Protocols


Bacterial Transformation

  • Thaw 100 ul of competen cells (per transformation) on ice just before they are needed
  • Add DNA (max 20ul) thawed cells and mix by flicking the side of the tube. Leave on ice for 30 minutes
  • Heat shock for 2 minutes at 42 degrees Celsius or 5 minutes at 37 degrees Celsius
  • Place on Ice for 5 minutes
  • Add 250ul SOC medium to each tube
  • Incubate for 30 to 60 minutes with shaking at 37 degrees Celsius. (Note that for Kanamycin containing plasmides always use one hour)
  • Spin down to remove all supernatant except approximately 100 ul
  • Plate approximately 30 ul on each of two antibiotic plates
  • Grow overnight at 37 degrees Celsius

For this protocol we used three controls

  • Positive Control - pBluescript in TOP10 cells on amp resistant plates
  • Negative Control - TOP10 cells grown on amp resistant plates
  • Negative Control - DB31 cells on amp resistant plates

Rehydration

Biobrick parts are shipped from the registry in a dehydrated from. As such they must be rehydrated before they can be used.

  • Puncture a hole through the foil with a pipette tip into the well that corresponds to the Biobrick - standard part that you want
  • Add 15 ul of diH20 (deionized water)
  • Take 1 ul DNA and transform into your desired competent cells, plate out onto a plate with the correct antibiotic and grow overnight. Your goal here is to obtain single colonies

For this protocol we used three controls

  • Positive Control - pBluescript in TOP10 cells on amp resistant plates
  • Negative Control - TOP10 cells grown on amp resistant plates
  • Negative Control - DB31 cells on amp resistant plates