Tokyo/Works/Simulation

From 2007.igem.org

Revision as of 03:58, 27 October 2007

Works top   0.Hybrid promoter   1.Formulation   2.Assay1   3.Simulation   4.Assay2   5.Future works

Numerical analysis and kinetic simulations for cell population

Multi-cell simulations with Hill coefficients of the promoters were carried out to find ranges of other parameters that lead the system to balanced differentiation. The differential equations for N cells were constructed to describe the cell population interacting with each other(Ex3.1).

Ex3.1 the differential equations of population model

Here the concentrations of AHL inside and outside of the cell are assumed to be the same since AHL is freely permeable though cell membranes. .

First, the phase plane analysis focused on individual cells.

To analyze the behavior of the cell population, the above differential equations for N cells were extended to the stochastic differential equations(Ex3.2). (see detailed derivation ) In order to carry out the simulations with the stochastic model, Poisson random variables were introduced into the differential equations. As a result of the stochastic simulation, the different behaviors of individual cells were observed.

Ex3.2 the stochastic differential equations of the population model

In the simulations, Hill coefficients, coefficients of repression and activation of AHL and LacI（n2,n3,k2,k3) determined by the wet experiments were used.The values of other parameters were determined by reference to some journals. (Kobayashi et al, 2004;Tian T et al, 2006;Garcia-Ojalvo J et al, 2004;Tomioka R et al, 2004)

Determining the range of parameter which satisfy balanced differentiation

Depending on the value of parameter λ, three different patterns were observed: the pattern with coexistence state of A and B states, the pattern with only A state, and the pattern with only B. The simulation results for their patterns are shown in Fig.1 to 3.

Fig.1.A 　t=0.0(min)

Fig.1.B 　t=3.0(min)

Fig.1.C 　 t=30(min)　only A

⇒ movie here!!

Fig.2.A 　t=0.0(min)

Fig.2.B 　t=3.0(min)

Fig.2.C 　 t=30(min) A-B balanced differentiation !!

⇒ movie here!!

Fig.3.A 　t=0.0(min)

Fig.3.B 　t=3.0(min)

Fig.3.C 　 t=30(min)　only B

⇒ movie here!!

The nullclines changed dependent on the state of the cell population. When there are only B cells, the nullclines had one intersection in the phase plane. As change of the state of the cell population, the number of the intersections of nullclines turned into two. Fig.4.A-C shows the appearance of an additional intersection, indicating an unstable equilibrium point, for the three patterns, respectively.

Fig.4.A

Fig.4.B

Fig.4.C

⇒ movie about Fig.4.A here!!

⇒ movie about Fig.4.B here!!

⇒ movie about Fig.4.C here!!

In Fig. 4B, the cell population was distributed around the unstable equilibrium point. Right after the moment shown in the Fig. 4B, some cells moved to the A state while the others go toward the B state. The division of the direction may have occurred due to the distribution of the population over the both sides of a “watershed,” a division line lying over the unstable equilibrium point. In another possibility, fluctuation of the cell state might allow going across the division line.

In the case of Fig. 4C, all the cells existed on the B-side across the dividing line from the B-side. Therefore, all the cells were not able to cross over the dividing line and moved to the B state. When all the cells existed on the A-side not the B-side ( Fig 4.A), all the cells moved to the A state, similarly.

The range of parameter λ

To determine the range of the value of parameter λ for balanced differentiation, further simulations were carried out by changing the value of λ. As a result, the relationship between the value of λ and the probability of balanced differentiation was determined as shown in Fig.5.

Fig.5

By using parameter λ in this range, we can construct the artificial genetic circuit for balanced differentiation!　It would be not difficult to adjust AHL production efficiency within this range by adjustment of promoter and RBS sequences.

In addition, the result of further simulation was found that when tha value of parameter lambda was fixed, the parameter ALPHA2 needed to be larger than ALPHA1 for the system to balanced differentiation.where ALPHA1,ALPHA2 are the expression rate of Ra and Rb.

Fig.6

supplementary Click here!!