From 2007.igem.org

Revision as of 18:05, 23 October 2007 (view source) Nakatani (Talk | contribs) ← Older edit		Latest revision as of 04:29, 27 October 2007 (view source) Kiga (Talk | contribs) (→Expression level check on ''promoters + plasmid sets'' of A and B sides)
(79 intermediate revisions not shown)
Line 1:		Line 1:
	__NOTOC__		__NOTOC__
-	<br>[[Tokyo/Works|Works top]]　　0.[[Tokyo/Works/Hybrid promoter|Hybrid promoter]]　　1.[[Tokyo/Works/Formulation |Formulation]]　　2.[[Tokyo/Works/Assay |Assay1]]　　3.[[Tokyo/Works/Simulation |Simulation]]　　4.[[Tokyo/Works/Assay2 |Assay2]]　　5.[[Tokyo/Works/Future works |Future works]]	+	<br>[[Tokyo/Works|Works top]]&nbsp;&nbsp;&nbsp;0.[[Tokyo/Works/Hybrid promoter|Hybrid promoter]]&nbsp;&nbsp;&nbsp;1.[[Tokyo/Works/Formulation |Formulation]]&nbsp;&nbsp;&nbsp;2.[[Tokyo/Works/Assay |Assay1]]&nbsp;&nbsp;&nbsp;3.[[Tokyo/Works/Simulation |Simulation]]&nbsp;&nbsp;&nbsp;4.[[Tokyo/Works/Assay2 |Assay2]]&nbsp;&nbsp;&nbsp;5.[[Tokyo/Works/Future works |Future works]]
-	Fomulationで建てた式に必要なパラメータをAssay１により実験的に求めた。それを導入した結果を解析したところ、以下の実験の必要性が浮かび上がった。	+	<br><br>
		+	[[Tokyo/Activation check by cell-produced AHL |Activation check by cell-produced AHL ]]&nbsp;&nbsp;&nbsp;[[Tokyo/Expression level check|Expression level check on ''promoters + plasmid sets'' of A and B sides]]
		+	==Objective==
		+	<!--<br>Fomulationで建てた式に必要なパラメータをAssay１により実験的に求めた。それを導入した結果を解析したところ、以下の実験の必要性が浮かび上がった。-->
-	==Endogenous AHL assay==	+	Parameters for the equations in [[Tokyo/Works/Formulation |Formulation]] have been experimentally determined in [[Tokyo/Works/Assay |Assay1]]. On the basis of the results of [[Tokyo/Works/Simulation |the simulations]], the following experiments were carried out to identify the nature of the current circuit construction.
-	==Comparison of promoter activity==	+	== [[Tokyo/Activation check by cell-produced AHL |Activation check by cell-produced AHL ]] ==
		+	[[Image:Endogenous.jpg|thumb|300px| '''Fig.1''' By culturing with AHL producing cells, whether the lux lac hybrid promoter was activated without externally adding AHL. Regardless of the copy numbers of the luxI encoding plasmids, the hybrid promoter was activated.]]
		+	'''Objective '''
		+
		+	To check whether worker E. coli (Sender) can produce enough amount of AHL for our model to work by using different copy numbers of plasmids
		+
		+
		+	'''Result & Conclusion'''
		+
		+	Not only a high-copy-number-plasmid pSB1 derivative, but also low copy number plasmid pSB4- and pBR derivatives produced enough AHL to activate the LacI hybrid promoter in other cells. Especially, the pBR derivative planned to use in the current construction, remarkably produced AHL in the present experiments.
		+	<br>
		+
		+	<br>
		+
		+	==== ==> see more [[Tokyo/Activation check by cell-produced AHL|details]]====
		+
		+	<br>
		+
		+	<br>
		+	<br>
		+	<br>
		+	<br>
		+
		+	==[[Tokyo/Expression level check|Expression level check on ''promoters + plasmid sets'' of A and B sides]]==
		+
		+	'''Objective '''
		+	[[Image:promoter hikaku.JPG|thumb|300px| '''Fig.2''' Expression levels of the both sides were compared. As to the A side, RFP was substituted with GFP.]]
		+
		+	<br>Aimulations indicated that not only relative AHL production efficiency, but production ratio of a repressor to the other is important for balanced differentiation. To test and compare the gene expression level of each side, A and B of the current genetic circuit construction.
		+	Since the cell type - A or B - is detected based on the fluorescence, its activity should be measured and standardized beforehand.
		+	Here we used the same fluorescent protein GFP on the both promoter + plasmid sets actually used in our model, where A side consists of Lambda cI-regulated promoter, and B side the lux lac hybrid promoter.
		+	<br><br>
		+	'''Result & Conclusion'''
		+	<br>Two plasmid sets, A4 ΔP/pc1-GFP(upper side of Fig.2, off/on respectively) and A4 hybrid-promoter(+AHL to activate)/pBR322tetR (lower side of Fig.2, on/off respectively), showed almost the same fluorescence of GFP. This result indicates that expression levels of both sets were almost the same, though the latter was a bit smaller. In the next construction, RBS and/ or promoter modifications are required to adjust the expression balance of the repressors. [[Image:pC1GFP.jpg|thumb|300px| '''Fig.3''' Genes downstream of the promoters on the both sides were expressed to almost the same degrees in terms of GFP fluorescence.]]
		+	<br><br>
		+
		+
		+
		+	==== ==> see more [[Tokyo/Expression level check|details]]====

---

Latest revision as of 04:29, 27 October 2007

Works top   0.Hybrid promoter   1.Formulation   2.Assay1   3.Simulation   4.Assay2   5.Future works

Activation check by cell-produced AHL    Expression level check on promoters + plasmid sets of A and B sides

Objective

Parameters for the equations in Formulation have been experimentally determined in Assay1. On the basis of the results of the simulations, the following experiments were carried out to identify the nature of the current circuit construction.

Activation check by cell-produced AHL

Objective

To check whether worker E. coli (Sender) can produce enough amount of AHL for our model to work by using different copy numbers of plasmids

Result & Conclusion

Not only a high-copy-number-plasmid pSB1 derivative, but also low copy number plasmid pSB4- and pBR derivatives produced enough AHL to activate the LacI hybrid promoter in other cells. Especially, the pBR derivative planned to use in the current construction, remarkably produced AHL in the present experiments.

==> see more details

Expression level check on promoters + plasmid sets of A and B sides

Objective

Aimulations indicated that not only relative AHL production efficiency, but production ratio of a repressor to the other is important for balanced differentiation. To test and compare the gene expression level of each side, A and B of the current genetic circuit construction. Since the cell type - A or B - is detected based on the fluorescence, its activity should be measured and standardized beforehand. Here we used the same fluorescent protein GFP on the both promoter + plasmid sets actually used in our model, where A side consists of Lambda cI-regulated promoter, and B side the lux lac hybrid promoter.

Result & Conclusion

Two plasmid sets, A4 ΔP/pc1-GFP(upper side of Fig.2, off/on respectively) and A4 hybrid-promoter(+AHL to activate)/pBR322tetR (lower side of Fig.2, on/off respectively), showed almost the same fluorescence of GFP. This result indicates that expression levels of both sets were almost the same, though the latter was a bit smaller. In the next construction, RBS and/ or promoter modifications are required to adjust the expression balance of the repressors.

==> see more details