Calgary/software

From 2007.igem.org

< Calgary
Revision as of 05:17, 27 October 2007 by Pjadamia (Talk | contribs)

back to U of C Homepage Check out evoGEM
Projects Design: Wet Lab Design: Printer Design: Software Testing Construction: The Wetlab Protocols Final Result of E.co Lisa

Our project made use of a very unique piece of software known as PlotterPilot. This program was able to conver NS-Bezier paths into a series of objective C commands that could be translated into motion by a printer system. Our system uses VHDL code to handle the FXS chip of our control ciruct.

Retrieved from "http://2007.igem.org/wiki/index.php/Calgary/software"