Calgary/software

From 2007.igem.org

< Calgary
Revision as of 05:16, 27 October 2007 by Pjadamia (Talk | contribs)

back to U of C Homepage Check out evoGEM

Our project made use of a very unique piece of software known as PlotterPilot. This program was able to conver NS-Bezier paths into a series of objective C commands that could be translated into motion by a printer system. Our system uses VHDL code to handle the FXS chip of our control ciruct.

Some of the code used by our project can be found Retrieved from "http://2007.igem.org/wiki/index.php/Calgary/software"