Virginia Tech/bacteria model

From 2007.igem.org

(Difference between revisions)
Line 90: Line 90:
[[Image:Bacterial_Growth_Curve.PNG|thumb|left|400px|Bacterial Growth measured by Plate Reader]]
[[Image:Bacterial_Growth_Curve.PNG|thumb|left|400px|Bacterial Growth measured by Plate Reader]]
 +
 +
 +
Population growth curves tend to have a sigmoid growth trajectory.  In order to create a sigmoid growth curve, we start with Michaelis Menten's (site source) model that describes enzyme kinetics with a limiting substrate.  The Michaelis Menten reaction equation is
 +
 +
[[Image:MMeq.jpg|thumb|left|400px|Bacterial Growth measured by Plate Reader]]
|}<html></center></html>
|}<html></center></html>

Revision as of 01:00, 24 October 2007

Title progress.JPG

Dot1.JPG

Dot1.JPG

Dot1.JPG

Dot1.JPG

Dot1.JPG

1st Scale: Bacterial Growth

Contents

The first step to modeling the spread of an epidemic is to model the population itself.

If you do not understand how the population grows, then how is it possible to understand the spread of a disease through that population? It is very easy to grow E. coli; it only needs some media, a warm environment, and some aeration. The problem is generating the growth curve. It is possible to measure the OD600 over a period of time, but the team wanted to generate data with number of bacteria.

Collecting Experimental Data

Generating the Calibration Curve

The team decided to generate OD600 vs Time, OD600 vs CFU/mL, and CFU/mL vs Time curves. It was also decided to grow two different strains of bacteria C600 and LE392 in both LB and TNT media.

This was accomplished using the following procedure:

ATCC C600 and LE392 were regenerated from a previous overnight culture. These cultures were used to inoculate four Corning Tubes labeled: "LE392 in TNT," "LE392 in LB," "C600 in TNT," and "C600 in LB." (These were the four different growth curves generated). Each culture was allowed to grow for at 37oC and 220 rpm. Aliquots were taken every 30 minutes starting at T=0. An OD600 was taken from each of these aliquots. Serial dilutions were made of each aliquot and they were then plated to grow overnight. This was done for a total of four hours.

The plates provided us with colony forming units per mL (CFU/mL), which could then be graphed against OD600. This provided the calibration curve necessary to determine number of cells per well.

Measuring Bacterial Growth

After producing a calibration curve to convert OD600 measurements to total number of cells, we decided to use the new plate reader to measure growth of LE392 in a single well. The new plate reader allows for temperature control, shaking, and can take numerous readings very quickly. Thus, we could follow the growth of LE392 in 96 wells without a considerable amount of work. The only problem was the small volume in each well made it easy for evaporation to occur, but this was compensated for by adding sterilized MilliQ water part of the way through the experiment.

Bacterial Growth measured by Plate Reader


Population growth curves tend to have a sigmoid growth trajectory. In order to create a sigmoid growth curve, we start with Michaelis Menten's (site source) model that describes enzyme kinetics with a limiting substrate. The Michaelis Menten reaction equation is

Bacterial Growth measured by Plate Reader