Tokyo/Formulation/3.AHL-experssing model

From 2007.igem.org

(Difference between revisions)
Line 1: Line 1:
__NOTOC__
__NOTOC__
-
<br>[[Tokyo/Works|Works top]]  0.[[Tokyo/Works/Hybrid promoter|Hybrid promoter]]  '''1.[[Tokyo/Works/Formulation |Formulation]]'''  2.[[Tokyo/Works/Assay |Assay1]]  3.[[Tokyo/Works/Simulation |Simulation]]
+
<br>[[Tokyo/Works|Works top]]  0.[[Tokyo/Works/Hybrid promoter|Hybrid promoter]]  '''1.[[Tokyo/Works/Formulation |Formulation]]'''  2.[[Tokyo/Works/Assay |Assay1]]  3.[[Tokyo/Works/Simulation |Simulation]]  4.[[Tokyo/Works/Assay2 |Assay2]]  5.[[Tokyo/Works/Future works |Future works]]
<br><br>[[Tokyo/Formulation/1.toggle model |Step1]]  [[Tokyo/Formulation/2.toggle model with hybrid promoter |Step2]]  [[Tokyo/Formulation/3.AHL-experssing model|Step3]]  
<br><br>[[Tokyo/Formulation/1.toggle model |Step1]]  [[Tokyo/Formulation/2.toggle model with hybrid promoter |Step2]]  [[Tokyo/Formulation/3.AHL-experssing model|Step3]]  
<br>
<br>

Revision as of 20:01, 26 October 2007


Works top  0.Hybrid promoter  1.Formulation  2.Assay1  3.Simulation  4.Assay2  5.Future works

Step1  Step2  Step3  

Step.3 Single cell model with hybrid promoter and cell-produced AHL


The differential equaitons of the system considering AHL produced by E.coli themselves were given as


Ex 3-1
Table 3


These equations were normalized as follows:


Ex 3-2


In the steady state,time derivatives are zero.As a result,the nullclines of this system were derived as


Ex 3-3


By substituting the third equation into the second,the nullclines for Ra and Rb were obtained as


Ex 3-4


Therefore, the phase plane of this system can be plotted as Fig.3.1.A-D and the number of equilibrium points were decided by the value of the parameters:


Figure 3.1.A

Figure 3.1.B

Figure 3.1.C

Figure 3.1.D

Fig3.1.A and B indicated that in case of N2=1,N3=1,the phase plane was monostable and in case of N2=2,N3=2,the phase plane was bistable. So, to take bistability the values of Hill coefficients were needed to be more than a certain value. Although the phase plane depended on the value of parameter λ,this value was controlled by changing the RBS of LuxR or the binding sequence of that.