From 2007.igem.org

Revision as of 13:36, 24 October 2007

• Home
  • Site Map
  • Meet the Team
  • Fun with iGEM
  • IcGEMs@OpenWetware
  • Acknowledgements
• Infector Detector
  • Introduction
  • Specification
  • Design
  • Modelling
  • Implementation
  • Testing/Validation
  • F2620 Comparison
  • Conclusion
• Cell by Date
  • Introduction
  • Specification
  • Design
  • Modelling
  • Implementation
  • Testing/Validation
  • Conclusion
• Cell-Free
  • What is Cell-Free?
  • Cell-Free Vs. Cell
  • Our Contributions
  • Characterisation
  • Applications
• Wet Lab
  • Lab Notebook
  • Protocols & Results
  • DNA Constructs
• Dry Lab
  • Modelling
  • Data Analysis
  • Software

Cell by Date: Testing

Testing and Discussion

Investigation properties of system under isothermal scenarios

In order to investigate the properties of our system we began by looking at isothermal scenarios in order to determine primarily the activation energy of our sytem following Giannuzzi's work with beef. Again this is useful because as per Taoukis' research for a TTI to function correctly its activation energy needs to be close to the target product. In Figure 1 above we see that under isothermal conditions a steady rate of fluoresence was observed, corresponding to a steady rate of protein production. This rate increase with temperature as per our predictions as protein production is linked to the kinetics of translation and so temperature. We have been able to extract the rate of protein production for range of temperature and made an arrhenius plot to further explore translation kinetics. A strong linear correlation in the log plot seems to suggest that an arrhenius type dependance on temperature seems to fit the translation mechanism. From this we have been able to calculate the activation energy as 1.5kJ/mol.

In addtion to calculating the activation energy through these experiments we have also been able to determine the operating range of our system. Our system seems to 'turn off' at around 4 degrees C. At 8 degrees with have minimal expression which then increases to a substantial expression at 37 degrees. Unfortunetly we have not been able to use a visible reporter and so have no idea whether the construct can in fact produce a visible signal. In terms of lifespan we have had major problems with evaporation meaning that the lifespan of our system is limited to a few days.

Investigation System properties under Dynamic Temperature Conditions

Response time extraction still to do

Validation and Conclusion

Conclusion still to do

Navigation