Imperial/Cell by Date/Testing

From 2007.igem.org

(Difference between revisions)
m
m (Validation and Conclusion)
Line 60: Line 60:
==Validation and Conclusion==
==Validation and Conclusion==
-
 
-
{|border="1" width="80%" align="center"
 
-
|-
 
-
|width="20%" style="background:#ffffcc"|<center>'''Property'''</center>
 
-
|width="--"|<center>'''Value'''</center>
 
-
|<center>'''Achieved ?'''</center>
 
-
|-
 
-
|style="background:#ffffcc"|Inputs
 
-
|<center>Isothermal conditions between 0 & 40 C</center>
 
-
|<center> No </center>
 
-
 
-
|-
 
-
|style="background:#ffffcc"|
 
-
|<center>Dynamic conditions eg. steps & ramps</center>
 
-
||<center>hmm</center>
 
-
|-
 
-
|style="background:#ffffcc"|Outputs
 
-
|<center>System should give a visual signal to indicate level of thermal exposure where beef is off</center>
 
-
|<center>No we were unable to use a visual reporter</center>
 
-
|-
 
-
|style="background:#ffffcc"|Activation Energy
 
-
|<center>System needs to have an activation Energy 30 +/- 20 kJ/mol</center>
 
-
||<center>No activation energy of system was calculated to be 1.5kJ/mol</center>
 
-
|-
 
-
|style="background:#ffffcc"|Health Regulations
 
-
|<center>System must not be living replicating bacteria</center>
 
-
|<center>Yes through use of cell free chassis</center>
 
-
|-
 
-
|style="background:#ffffcc"|Response Time
 
-
|<center>System needs to have a response time under 1 hour</center>
 
-
||<center>hmm tbd</center>
 
-
|-
 
-
|style="background:#ffffcc"|Lifespan
 
-
|<center>System must have a shelf life of 7 days</center>
 
-
||<center>No with current packaging methods evaporation meant that our system 'died' after 2 days</center>
 
-
|}
 
-
<br clear="all">
 
-
 
-
Conclusion still to do
 

Revision as of 18:23, 26 October 2007



Cell by Date: Testing

Testing and Discussion

Investigation properties of system under isothermal scenarios

To estimate the properties of our system we looked at the evolution of the Fluorescence with time for experiments where temperature is carefully kept constant. (Figure 1).
General Behaviour:

  • In all experiment we can observe a linear growth of fluorescence corresponding to a steady rate of protein production.
  • This matches the claims of the manufacturer of the cell-free extract that the extract is optimised so that protein degradation is negligible.

Isothermal Data

Operating Range:

  • Our system seems to 'turn off' at around 4 degrees C.
  • At 8 degrees with have minimal expression which then increases to a substantial expression at 37 degrees.

Synthesis rate vs Temperature

  • Over the range of temperature considered here the rate increases with temperature.
  • To investigate the relation between synthesis rate and temperature we extracted the rate of synthesis of GFP for each experiment and plotted it against 1/T (Figure 2).
  • A strong linear correlation in the log plot supports an arrhenius type dependence on temperature with an activation energy of 1.5kJ/mol.

Arrhenius Plot

Other practical considerations:

  • Unfortunetly we have not been able to use a visible reporter and so have no idea whether the construct can in fact produce a visible signal.
  • In terms of lifespan we have had major problems with evaporation meaning that the lifespan of our system is limited to a few days.

dirkadirak everything aftther this is not what matthieu sent me

In order to investigate the properties of our system we began by looking at isothermal scenarios in order to determine primarily the activation energy of our sytem following Giannuzzi's work with beef. Again this is useful because as per Taoukis' research for a TTI to function correctly its activation energy needs to be close to the target product. In Figure 1 above we see that under isothermal conditions a steady rate of fluoresence was observed, corresponding to a steady rate of protein production. This rate increase with temperature as per our predictions as protein production is linked to the kinetics of translation and so temperature. We have been able to extract the rate of protein production for range of temperature and made an arrhenius plot to further explore translation kinetics. A strong linear correlation in the log plot seems to suggest that an arrhenius type dependance on temperature seems to fit the translation mechanism. From this we have been able to calculate the activation energy as 1.5kJ/mol.

In addtion to calculating the activation energy through these experiments we have also been able to determine the operating range of our system. Our system seems to 'turn off' at around 4 degrees C. At 8 degrees with have minimal expression which then increases to a substantial expression at 37 degrees. Unfortunetly we have not been able to use a visible reporter and so have no idea whether the construct can in fact produce a visible signal. In terms of lifespan we have had major problems with evaporation meaning that the lifespan of our system is limited to a few days.

Investigation System properties under Dynamic Temperature Conditions

CBD Steps.pngCBD Steps.png

Response time extraction still to do

Validation and Conclusion

<< Implementation | Testing/Validation | Conclusions >>