Imperial/Wet Lab/Lab Notebook/2007-10-19

From 2007.igem.org

< Imperial | Wet Lab | Lab Notebook(Difference between revisions)
 
(3 intermediate revisions not shown)
Line 1: Line 1:
 +
{{Template:IC07navmenu}}
 +
<html><div id="maincol"></html>
 +
__NOTOC__
 +
 +
==AHL titration curve for infector detector construct==
==AHL titration curve for infector detector construct==
*The '''aim'' of this experiment was to test the pTet-luxR-pLux-GFPmut3b construct with a range of AHL concentrations. A titration curve could then be created for the construct in terms of AHL concentrations
*The '''aim'' of this experiment was to test the pTet-luxR-pLux-GFPmut3b construct with a range of AHL concentrations. A titration curve could then be created for the construct in terms of AHL concentrations
Line 7: Line 12:
**pTet-luxR-pLux-GFPmut3b construct with [AHL] = 0nM
**pTet-luxR-pLux-GFPmut3b construct with [AHL] = 0nM
*The [[Imperial/Wet Lab/Results/ID3.1|Results]] showed that the total fluorescent output produced by the construct increases with increasing [AHL]
*The [[Imperial/Wet Lab/Results/ID3.1|Results]] showed that the total fluorescent output produced by the construct increases with increasing [AHL]
 +
 +
 +
 +
<html></div></html>
 +
{{Template:IC07labnotebook}}

Latest revision as of 18:59, 26 October 2007


AHL titration curve for infector detector construct

  • The 'aim of this experiment was to test the pTet-luxR-pLux-GFPmut3b construct with a range of AHL concentrations. A titration curve could then be created for the construct in terms of AHL concentrations
  • The materials and methods can be found in the Protocols
  • The concentrations of AHL for which the construct was tested are: 0nM, 5nM, 10nM, 15nM, 20nM, 50nM, 100nM, 1000nM
  • There were two negative controls for the experiment:
    • Empty vector with [AHL]=1000nM
    • pTet-luxR-pLux-GFPmut3b construct with [AHL] = 0nM
  • The Results showed that the total fluorescent output produced by the construct increases with increasing [AHL]